Specifications

Chapter 5: Replacing Assemblies
Removing and Replacing the Fans
103
4
Clip off the end of each of the fan mounts (see Figure 5- 69) and take the fan
out. Repeat for each fan that needs to be replaced.
Figure 5-69
CAUTION AVOID OVERHEATING THE OSCILLOSCOPE
When replacing the fan, be sure the direction of the fan air flow is coming from the
inside to the outside of the oscilloscope. Check the flow arrows on the fan and check
for proper flow once power is applied to the oscilloscope. Improper air flow can overheat
the oscilloscope.
5
To install the fan, reverse this procedure.