Specifications

Table 1. Softkey Descriptions {16 of 17)
Key Name
Suppr. Plot
System
Clock
System
Config
System
Preset
Take Sweep
Test All
Test Files
Test Mode
Normal
Trouble
Shoot
(cont'd)
Description
Accesses the PLL Suppression Plot. This softkey
only appears when an Accuracy Specification
Degradation is detected. The PLL Suppression Plot is
automatically displayed when the Troubleshoot Mode
has been selected.
Provides access to the systems real time clock.
Accesses the System Configuration Table. All
equipment to be controlled over the HP-IB interface
must be listed in this table.
Allows you to reset the system hardware to its
predefined turn-on state. System preset loads the
Default data files and configures the HP 3048A to
make its demonstration measurement when the
New Measurement softkey is pressed.
Initiates measurement of the span selected in the
Noise Monitor display.
Selects all of the available tests.
Accesses the Test File Directory. You may load or
store Test Files from this menu.
Allows selection of the Normal, Trouble Shoot, or
Ignore Out-of-lock mode.
Default Test Mode; PLL suppression is not plotted
unless an accuracy specification degradation of
>1dB is measured.
Enables plotting of the PLL suppression during its
characterization and provides access to 11848A
Control at the Connect Diagram and other displays.
Chapter
5 System
Configuration
6 System
Configuration
6 System
Configuration
None
5 Special
Functions
HP 3048A
Calibration
Manual
2 Meas.
Definitions
5 Special
Functions
Softkey Index 19