Manualshelf

Technical data

ManualsBrandsAgilent Technologies ManualsPower ToolsHP 70903A IF SECTION
21222324252627282930
an
8 mm hex-ball driver while pressing against module
front.
5 .
Connect module cables.
6 .
Close the mainframe front-panel door.
7.
Turn the mainframe LINE switch on.
LINE
MODULE
DOOR
WITC H
LATCH
Figure 2-2. Module Installation
24 Installation
mainf?ame.
Tighten module latch using
Turn
the mainframe LINE switch off.
Open the mainframe front-panel door.
Slide the module into the
#
To avoid blowing the mainframe line fuse or internal module fuses, the
mainframe power must be turned off before connecting or disconnecting
modules.
Module Installation
1.
2.
3 .
4.
Mainframe
The HP 70903A must be installed in an HP 70000 Series mainframe. This is accomplished by
following the procedure below. Figure 2-2 identifies the module and mainframe parts called
out in the procedure.
Caution
Installing the Module in the