Specifications

5-8
Getting Started
Making Your First Measurement
To select PRESET 0 press the display key, and to select PRESET 1 or
PRESET 2 select , , then or
.
For this procedure we set the error performance analyzer to its default values by select-
ing PRESET 0. Refer to Chapter 9 for a list of settings for each PRESET.
5. Press the green key.
Figure 5-4 System Back-to-Back Connection
Perform a data eye measurement
In the following steps the data eye edge threshold is set, and the clock and data inputs
aligned such that the error detector samples in the middle of the eye (in the time axis).
6. Before performing the measurement select , then select
. No eye results will be displayed until clock-data alignment is
performed in step 9 of this procedure.
7. Press the hardkey on the display hardkey panel.
INST PRESET
trigger & setup
recall setup Preset 1
Preset 2
INST PRESET
result pages
EYE RESULTS
input & eye