Specifications

5-6

Getting Started

System Turn-On

Introduction

The getting started procedures assume that the Agilent 71612 series systems have been

correctly installed and configured as described in Chapter 2 Installation.

WARNING Beforeturning the system on, make sure it is grounded through the

protective conductor of the ac power cable to a socket outlet

provided with protective earth contact. Any interruption of the

protective (grounding) conductor inside or outside the system, or

disconnection of the protective earth terminal, can result in

personal injury. (Refer to page 1-2 for safety considerations).

CAUTION Do not turn on the Agilent 71612 Series Systems until they have been

configured and fused for the available line voltage, and safely

connected to the power line (115V or 230V).

CAUTION Do not attempt to replace or remove clock modules while instruments

are powered up as it may damage modules. Switch off the Agilent

70004A Display before replacing or removing modules.

NOTE The Agilent 71612 Series Systems will not function correctly unless

each instrument in the system is cabled correctly for HP-MSIB

operation, and each instrument is powered up. Refer to Chapter 2

Installation for information on cabling.