Specifications

2-20

Installation

Installing/Removing Modules

This section describes how you install a clock source module into a Display and

Mainframe.

Installing an Agilent 70340A Clock Source Module into a Display

Use the following procedures to install your clock source into the display. To remove a

module, perform the steps in the reverse order.

1. Set the display LINE power switch to off.

2. Open the front panel door then insert the module.

3. Secure the module by pressing against its front panel while tightening the hex-nut latch

with an 8 mm hex-ball driver.

When removing a clock source module, disconnect any cables that may be connected to

the rear panel.