Specifications

5-46
System Command Reference Section
Error Detector Result and Configuration Logging
SENSe[1]:LOGGing:THReshold <numeric parm>
This command permits a threshold to be set against which logging conditions are
compared to decide when some logged information is output.
The *RST selection is 1.00E−3.
SENSe[1]:LOGGing:DURing[:EVENt] NEVer|ESECond|ERGThrshld
This command selects which of three conditions apply when deciding when to log output
during a gating period. The choices are between ‘never’, ‘on the occurrence of an error
second’ and ‘when the error ratio over a second is greater than the threshold’.
The *RST selection is ESECond.
SENSe[1]:LOGGing:END[EVENt]NEVer| ALWays|NZECount|
TERGthrshld
This command selects which of four conditions apply when deciding when to log output at
the end of a gating period. The choices are between ‘never’, ‘always’, ‘only on non-zero
error count’ and ‘total error ratio greater than the threshold’.
The *RST selection is ALWays.
SENSe[1]:LOGGing:END:REPort FULL|UREP
This command selects what to output at the end of a gating period. The choices are
between ‘FULL’ that is, Main Results plus Interval Results plus G.821 Analysis, and
‘UREP’, that is results currently part of the User's Page.
The *RST selection is FULL.