Specifications

5-35
System Command Reference Section
Error Detector Error Location
SENSe[1]:BLOCK <boolean>
This command turns Block BER mode on or off.
SENSe[1]:BLOCK:BSTart <numeric value>
This command sets the start address of the block. Where the start bit number is configured
to be less than 32 bits from the end of the pattern the block BER function automatically
wraps around to include the appropriate number of bits at the start of the pattern.
SENSe[1]:BLOCK:BLENgth <numeric value>
This command sets the length of the block. It must be a multiple of 32.