Specifications

5-17

System Command Reference Section

Pattern Generator DATA OUT (inverted)

In this section the SOURCE10:VOLT and OUTPUT10 commands control the electrical

levels at the DATA OUT port. Refer to the previous section on page 5-15 for

SOURCE1:VOLT and OUTPUT1 commands which provide the controls for the

DATA OUT port.

NOTE See Handling Coupled Parameters,page2-11.

SOURce10:VOLTage[:LEVel][:IMMediate][AMPLitude] <numeric

value>

Sets the peak to peak value of the data signal, in units of Volts.

This command is allowed only when tracking is disabled.

The *RST selection is 500 mV.

SOURce10:VOLTage [:LEVel][:IMMediate]:HIGH <numeric value>

This is used to set the dc high output level, in units of Volts.

This command is allowed only when tracking is disabled.

The *RST selection is 0 V.

SOURce10:VOLTage:TRACK <boolean>

Enables the Data, Data Outputs to operate independently or track together.

The *RST selection is ON.

OUTput10 [:STATE] <boolean>

This node controls the data output. When OFF, the output is set to 0 V.

The *RST selection is ON.