Specifications

5-16
System Command Reference Section
Pattern Generator DATA OUT
OUTPut1:COUPling AC|DC
Sets the data output coupling to ac or dc.
The *RST selection is 0 V dc.
OUTPut1:POLarity NORMal|INVerted
Sets the polarity of the data output.
The *RST selection is NORMal.
OUTPut1:DELay <numeric value>
Sets the delay of the active edge of the clock output relative to the data output. The units
are seconds. The value is rounded to the nearest one picosecond.
The *RST selection is 0 ps.
OUTPut1:XOVER<numeric value>
Sets the value which vertically adjusts the voltage at which the 1 to 0 and the 0 to 1
transitions cross. The value entered specifies a signed deviation from the calibrated 50%
cross over setting normally used.
The *RST selection is 0.
OUTPut1:TERMination <numeric value>
Enables the data termination level to be selected as 0 Volts or −2 Volts.
The *RST selection is 0 V.
OUTPut1:BITLength<numeric value>
Provides fine adjustment of the bit length of the main data and data outputs. The setting
range is between −100 and +100. A setting of 0 will leave the bit length at the calibrated
value.
The *RST selection is 0.