Specifications

10-3

Data Logging

Switches 5678 on the Microprint 45CH should be set to 0000 so that the adaptor sends no

resolution setting control to the printer. As there is no graphical output from the

Agilent 70843 other settings of switches 5678 will not affect the quality or size of the

logged output which is textual.

When using this interface adaptor the Agilent 70843 should be powered on last in order

that it does not detect any violation of the IEEE-488 handshake protocol which may result

from a power cycle of the adaptor. Any reconfiguration of the adaptor therefore requires

the adaptor to be power-cycled which then requires a further power cycle of the

Agilent 70843.

Printer Interface Cables

• GP-IB cable HP 10833A (1 m), HP 10833B (2 m), HP 10833C (4 m) or HP 10833D

(0.5 m).

• HP 92284A or HP 24542D Centronics 36-pin M, 25-pin M (2 m).

Printer Address

The printer address is set permanently to 1, and cannot be changed by the user.

Selecting Logging Functions

All logging functions are found by pressing the hardkey or by selecting

then the softkey. The following figure illustrates the logging softkeys

available to the user.

Data Logging Softkeys

logging