Specifications

8-14
User Patterns and Disk Operation
How to Set Up and Edit Your Own User Pattern
The following figures give an example of the contents of the user pattern memory before
and after is set to .
ALTPAT set to OFF
ALTPAT set to ON
5. Select the softkey, and set the correct pattern length. You must
ensure that you select a pattern length that is at least as large as the pattern to be loaded
into the user pattern memory. For this example select a length of 3000 bits using the
numeric keypad then press .
6. Position the cursor at the point in the pattern where you wish the block of data loaded
(in this case a 2^10 PRBS) - use the softkey. For this example set it to 0.
ALTPATT ON
SET PAT LENGTH
ENTER
goto bit