Specifications

8-10
User Patterns and Disk Operation
How to Set Up and Edit Your Own User Pattern
9. When you press or finish editing zero sub or mark density the display
returns to the main editing screen, with the PRBS pattern selected loaded into the editor
(user pattern memory) starting from the current cursor position. The cursor is
positioned after the last inserted bit (or at end of pattern) after the command is
complete.
10.To save the edited pattern, press then select a pattern store softkey.
To Load a User Pattern Into the Editor
The following procedure explains how to load the contents of a user pattern store into the
user pattern memory, at the current cursor position.
Procedure
1. Repeat steps 1 to 4 of the previous procedure (loading a PRBS).
2. Select - the menu changes to give a sub-menu set of softkeys, offering
the choice of selecting a fixed PRBS of , , or , or a or
.
3. Select the or softkey and proceed to
step 4.
Load Copies of User Patterns
When you select the or softkeys you are
offered the choice of loading more than one copy of the pattern. The number of copies you
make is however limited by the length of the current pattern in the user pattern memory.
4. If you wish more than one copy press , enter the number using
the display numeric keypad, then press .
5. Select the or store whose data you wish to load into
the user pattern memory.
The contents (block) of the pattern store you have just selected are now loaded into the
editor at the point highlighted by the cursor.
6. You can now elect to save the contents of the user pattern memory to a pattern store, or
edit further and then save to a pattern store. To save the block (pattern) you have
loaded, press , then select a pattern store or
.
NO MODIFY
save pattern
load block
2^7 2^10 2^11 2^13 ram
diskUsr pattern
ram Usr pattern diskUsr pattern
ram Usr pattern diskUsr pattern
#COPIES TO LOAD
ENTER
INTERNL PATT DISK PATT
save pattern INTERNL PATT
DISK PATT