Specifications

8-7
User Patterns and Disk Operation
How to Set Up and Edit Your Own User Pattern
6. The following figure gives an example of a pattern loaded from .
NOTE The following steps explain how to perform individual edit functions.
There is no need to complete the whole procedure; refer to each
explanation as required. It is assumed that the user is currently working
in the editor.
Set Pattern Length
1. Press the softkey - enter the pattern length using the numeric
keypad and press the softkey.
Insert/Replace Bits in the Pattern
1. Press the softkey to select the function required. The key label
underlined is the one selected.
It may be that the part of the pattern in which you wish to insert or replace bits is not
currently displayed. To view the part of the pattern containing the bits of interest you
can use the , or softkeys. For fast
access to a bit in a large pattern use the goto bit softkey. Set the cursor address (at bot-
tom of screen) to the number of the bit to be edited, then press . Use the
numeric keypad 1 and 0 keys to insert or replace bits in the pattern.
Delete Bits
1. Use the display knob or softkey to set the cursor to the bit number of the
bittobedeleted,thenpress .
INTERNL PATT1
SET PAT LENGTH
ENTER
INSERT/REPLACE
NEXT SCREEN PREV SCREEN goto bit
ENTER
goto bit
DELETE BIT