Specifications

Table 4-1
Recommended list of test equipment to service the oscilloscope
Equipment Critical specifications Recommended Model/Part Use
Constant amplitude
signal generator
100 MHz, Constant amplitude ±1%
(250 MHz for HP 54602)
Tek SG503
Tek TM501
P
Digital multimeter 0.1 mV resolution, better than 0.01%
accuracy
HP 34401A P, A, T
Oscilloscope 100 MHz HP 54600B or equivalent T
Power supply 14 mV to 35 Vdc, 0.1 mV resolution HP 6114A P
Probe 10:1 division ratio HP 10432A T
Pulse generator Rise time < 875 ps PSPL 1107B TD and PSPL 1110B Driver A
Pulse generator 10 kHz, 500 mV p-p, rise time <5 ns HP 8112A A
Time marker
generator
Stability 5 ppm after 1/2 hour TG 501A and TM 503A P
Feedthrough 50 Ω, BNC (m) and (f) HP 10100C P, A
Power splitter Outputs differ <0.15 dB HP 11667B P
Shorting cap BNC HP 1250-0774 P
Adapter SMA (f) to BNC (m) HP 1250-1787 A
Adapter BNC (f-f) HP 1250-0080 A
Adapter BNC tee (m) (f) (f) HP 1250-0781 A
Adapter N (m) to BNC (f), Qty 3 HP 1250-0780 P
Adapter BNC (f) to dual banana (m) HP 1251-2277 P
Cable BNC, Qty 3 HP 10503A P, A
Cable BNC, 9 inches, Qty 2 HP 10502A A
Additional equipment needed if you perform the alternate bandwidth test when verifying oscilloscope performance.
Signal generator 1 to 100 MHz at 200 mV
(250 MHz for HP 54602B)
HP 8656B opt 001 P
Power meter and
Power Sensor
1 to 100 MHz ±3% accuracy
(250 MHz for HP 54602B)
HP 436A and HP 8482A P
Cable Type N (m) 24 inch HP 11500B P
Adapter Type N (m) to BNC (m) HP 1251-0082 P
Service
4–3