Specifications

Contents
1 The Oscilloscope at a Glance
To inspect the instrument 1–6
To clean the instrument 1–6
To connect a signal to the oscilloscope 1–7
To display a signal automatically 1–9
To set up the vertical window 1–10
To set up the time base 1–12
To trigger the oscilloscope 1–14
To use roll mode 1–16
2 Operating Your Oscilloscope
To use delayed sweep 2–3
To use storage oscilloscope operation 2–6
To capture a single event 2–8
To capture glitches or narrow pulses 2–10
To trigger on a complex waveform 2–12
To make frequency measurements automatically 2–14
To make time measurements automatically 2–16
To make voltage measurements automatically 2–19
To make cursor measurements 2–22
To view asynchronous noise on a signal 2–26
To reduce the random noise on a signal 2–28
To save or recall traces 2–31
To save or recall front-panel setups 2–32
To reset the instrument setup 2–33
To use the XY display mode 2–34
To analyze video waveforms 2–38
Contents–1