Specifications

To select TV display grid
•
Press
Display
, then press the
Grid
softkey until
TV
is selected.
To autoscale on a video signal
1
Use a cable to connect a TV signal to channel 1.
2
Press
Mode
in the
TRIGGER
section of the front panel, and
select the
Trigger Mode TV
softkey.
3
To select a TV standard, press
Slope/Coupling
in the
TRIGGER
section of the front panel, then press the
Standard
softkey to select
the TV standard. Your cho
ices are
NTSC
,
PAL
,
SECAM
, and
GENERIC
.
GENERIC
is used for other TV/Video standards. If your TV standard
has been previously selected, you may skip this step.
4
Press
Mode
, then press the
Video Autoscale
softkey.
Provide correct source matching
Many TV signals are produced from 75Ω sources. To provide correct matching
to these sources, an HP 11094B 75Ω load is included as an accessory. For
oscilloscopes that have selectable input impedance, the 1 MΩ input should be
used with the 75Ω load.
The
Undo Autoscale
softkey in the
Setup
menu resets the instrument
to the configuration that was present before pressing
Video Autoscale
.
Using Option 005 Enhanced TV/Video Trigger (HP 54602B)
To select TV display grid
3–4