Specifications

Adjusting the Oscilloscope 4–27
To adjust the power supply 4–28
To perform the self-calibration 4–31
To adjust the low-frequency compensation 4–33
To adjust the high-frequency pulse response 4–35
To adjust the display 4–37
To adjust the Option 005 offset (R15)
(HP 54602B only)
4–39
Troubleshooting the Oscilloscope 4–40
To construct your own dummy load 4–41
To check out the oscilloscope 4–42
To check the Low Voltage Power Supply 4–45
To run the internal self-tests 4–46
To troubleshoot Option 005
(HP 54602B only)
4–48
Replacing Parts in the Oscilloscope 4–49
To replace an assembly 4–50
To remove the fan 4–51
To remove the front panel 4–51
To remove the display 4–53
To remove the system board 4–53
Power supply 4–54
Keyboard 4–55
To remove the handle 4–56
To remove the Option 005 board 4–56
To order a replacement part 4–57
Contents
Contents–3