Specifications

Check the setup/hold with single clock edges, multiple clocks
1 Select the logic analyzer setup/hold time.
a In the logic analyzer Format menu, select Master Clock.
b Select and activate any two clock edges.
c Select the Setup/Hold field and select the setup/hold to be tested for all pods. The first
time through this test, use the top combination in the following table.
Setup/Hold Combinations
4.5/0.0 ns
0.0/4.5 ns
2.0/2.5 ns
d Select Done to exit the setup/hold combinations.
2
Disable the pulse generator channel 1 COMP (with the LED off).
3 Using the Delay mode of the pulse generator channel 1, position the pulses
according to the setup time of the setup/hold combination selected, +0.0 ps or −100
ps.
a
On the Oscilloscope, select [Define meas] Define ∆ Time - Stop edge: rising.
b In the oscilloscope timebase menu, select Position. Using the oscilloscope knob,
position the rising edge of the clock waveform so that it is centered on the display.
c
On the oscilloscope, select [Shift] ∆ Time, then select [Enter] to display the setup time
(∆ Time(1)-(2)).
Testing Performance
To test the multiple-clock, multiple-edge, state acquisition (logic analyzer)
3–44