Specifications

To adjust the CRT monitor alignment
This procedure must be performed by trained personnel. Adjustments are made with
the cover removed and power applied.
WARNING
Do not touch the CRT monitor sweep board. High voltages exist on the sweep board that can
cause personal injury.
Equipment Required
Equipment Critical Specification Recommended
Model/Part
Alignment Tool 1 8710-1300
11 Turn off the logic analyzer, then disconnect the power cord. Remove the cover.
Refer to chapter 6, "Replacing Assemblies," for instructions to remove the cover.
2 Connect the power cord, then turn on the logic analyzer.
3 Insert the disk containing the functional performance verification tests into the disk
drive, then load the functional performance verification operating system into the
logic analyzer.
4–6