Instruction manual

Chapter 4 Retrofitting Options
To Retrofit the Rear Terminals (Option 060)
Assembly-Level Service Guide 4-15
4
NOTE For the Agilent 53181A, the front and rear terminals can exist for Channel 1.
However, Agilent 53181A’s optional Channel 2 input (Option 015/030) can be
configured as rear terminals only or front terminals only.
NOTE If there are upper or lower shields installed on A1 Motherboard Assembly, cut them
out and replace the front bezel with the metallized version (53131-40001).
Figure 4-3A. Plug Removal for Rear Terminals Retrofitting
3 Remove the end of the optional channel (Option 015/030) coaxial cable (W1) that is
connected to the front-panel and insert it through the appropriate rear INPUTS
opening (3 for Agilent 53131A/132A; 2 for Agilent 53181A) as shown in
Figure 4-3B.
Plug (MP9)
Panel