Instruction manual

Chapter 4 Retrofitting Options

To Retrofit A5 DC Power Input Assembly (Option 002)

Assembly-Level Service Guide 4-5

Retrofitting Procedure

1 Slide A1 Motherboard Assembly into the new chassis (MP10) as shown in

Figure 4-1A.

Figure 4-1A. DC Power Input Assembly Retrofitting

2 Insert but do not tighten the three TORX 15 screws (H1) that attach A1

Motherboard Assembly to the new chassis (MP10) as shown in Figure 4-1A.

3 Insert and tighten the three BNC nuts (H3) onto the BNC connectors that

protrude from the rear of the chassis using the 14-mm deep-socket spin tight.

4 Insert and tighten the two hex screws (H4) and the lock washers (H5) onto the

GPIB connector that protrudes from the rear of the chassis using the 7-mm spin

tight.

A1 Motherboard

Assembly

MP10