Instruction manual

Chapter 3 Replacing Assemblies
To Remove the Rear Terminals (Option 060)
Assembly-Level Service Guide 3-21
3
To Remove the Rear Terminals (Option 060)
1 Remove the cover.
See the section titled “To Remove the Cover” in this chapter.
2 Unsolder the lead-end of the cables from their appropriate ground and input
pads on the A1 Motherboard Assembly (J16, J17) as shown in Figure 3-13.
For the Agilent 53131A/132A unsolder the rear chassis INPUTS 1 cable to J16 and
INPUTS 2 to J17.
For the Agilent 53181A unsolder the rear chassis INPUTS 1 cable to J17.
NOTE If there are upper or lower shields installed on A1 Motherboard Assembly, cut them
out and then remove Option 060 Rear Terminal cable(s). Replace the front bezel with
the metalized version (53131-40001).