Technical data
Table Of Contents
- Contents
- Introduction
- System Description
- Installation
- Overview
- Step 1: Selecting a Location
- Step 2: Unpack and Inspect the Instrument
- Step 3: Set Up the Vacuum Pump
- Step 4: Connect the Power Cord
- Step 5: Install the Dry Compressed Air or O2 Supply
- Step 6: Install the Signal Output Cables
- Step 7: Install the Dual Plasma Burner
- Step 8: Install the Dual Plasma Controller
- Step 9: Install Column Connections
- Step 10: Install the Transfer Line
- Front Panel Controls and Initial Startup
- Operation
- Maintenance
- Pump Maintenance
- Cleaning the Detector
- Changing the Oil Mist Filter (RV5)
- Reaction Cell Cleaning
- Flow Sensor Calibration
- Detector Sensitivity
- Assembling the Dual Plasma Burner for Component Replacement with the SCD
- Assembling the Dual Plasma Burner for Component Replacement with the NCD
- Tube Replacement for the SCD
- Tube Replacement for the NCD
- Troubleshooting
- Index
86 Operation and Maintenance Manual
6
Use a 7/64" Allen wrench to remove the three mounting screws from the
reaction cell. Slowly pull the reaction cell back from the PMT housing. The
optical filter is located between the reaction cell and the PMT housing.
Remove the optical filter from the housing by tipping up the back of the
Detector, if necessary, and allow the filter to fall onto a soft cloth.
7 Inspect the o-rings and replace them if they show any wear.
Figure 23 Reaction Cell, PMT Housing and PMT Socket
Figure 24 Reaction Cell