Technical data
Table Of Contents
- Contents
- Introduction
- System Description
- Installation
- Overview
- Step 1: Selecting a Location
- Step 2: Unpack and Inspect the Instrument
- Step 3: Set Up the Vacuum Pump
- Step 4: Connect the Power Cord
- Step 5: Install the Dry Compressed Air or O2 Supply
- Step 6: Install the Signal Output Cables
- Step 7: Install the Dual Plasma Burner
- Step 8: Install the Dual Plasma Controller
- Step 9: Install Column Connections
- Step 10: Install the Transfer Line
- Front Panel Controls and Initial Startup
- Operation
- Maintenance
- Pump Maintenance
- Cleaning the Detector
- Changing the Oil Mist Filter (RV5)
- Reaction Cell Cleaning
- Flow Sensor Calibration
- Detector Sensitivity
- Assembling the Dual Plasma Burner for Component Replacement with the SCD
- Assembling the Dual Plasma Burner for Component Replacement with the NCD
- Tube Replacement for the SCD
- Tube Replacement for the NCD
- Troubleshooting
- Index
84 Operation and Maintenance Manual
Changing the Oil Mist Filter (RV5)
The oil mist filter on the RV5 pump has two components: the charcoal odor
filter and the oil coalescing filter element. To replace the filters, disassemble
the oil mist filter assembly with the 4 mm long-handled allen wrench
(provided). The smaller charcoal odor filter sits on top of the larger oil
coalescing filter element. It is recommended to replace the oil coalescing filter
element after 90 days of continuous use, however replacement of the charcoal
odor filter is optional. After replacing the filter, re-assemble the filter
assembly and attach it to the pump flange.