Technical data
Table Of Contents
- Contents
- Introduction
- System Description
- Installation
- Overview
- Step 1: Selecting a Location
- Step 2: Unpack and Inspect the Instrument
- Step 3: Set Up the Vacuum Pump
- Step 4: Connect the Power Cord
- Step 5: Install the Dry Compressed Air or O2 Supply
- Step 6: Install the Signal Output Cables
- Step 7: Install the Dual Plasma Burner
- Step 8: Install the Dual Plasma Controller
- Step 9: Install Column Connections
- Step 10: Install the Transfer Line
- Front Panel Controls and Initial Startup
- Operation
- Maintenance
- Pump Maintenance
- Cleaning the Detector
- Changing the Oil Mist Filter (RV5)
- Reaction Cell Cleaning
- Flow Sensor Calibration
- Detector Sensitivity
- Assembling the Dual Plasma Burner for Component Replacement with the SCD
- Assembling the Dual Plasma Burner for Component Replacement with the NCD
- Tube Replacement for the SCD
- Tube Replacement for the NCD
- Troubleshooting
- Index
Operation and Maintenance Manual 83
Cleaning the Detector
You can clean the external housing of the Detector with a damp cloth using
water or non-abrasive cleaners. Turn off power to the Detector and disconnect
it from main power prior to cleaning. Do not spray liquids directly on the
Detector. Wipe dry with a clean, soft cloth.
No cleaning agents which could cause a hazard as a result of reaction with the
Burner unit are to be used in cleaning the instrument.
Contact Agilent to address concerns about the compatibility of specific
cleaning agents with the Burner unit.