Technical data
Table Of Contents
- Contents
- Introduction
- System Description
- Installation
- Overview
- Step 1: Selecting a Location
- Step 2: Unpack and Inspect the Instrument
- Step 3: Set Up the Vacuum Pump
- Step 4: Connect the Power Cord
- Step 5: Install the Dry Compressed Air or O2 Supply
- Step 6: Install the Signal Output Cables
- Step 7: Install the Dual Plasma Burner
- Step 8: Install the Dual Plasma Controller
- Step 9: Install Column Connections
- Step 10: Install the Transfer Line
- Front Panel Controls and Initial Startup
- Operation
- Maintenance
- Pump Maintenance
- Cleaning the Detector
- Changing the Oil Mist Filter (RV5)
- Reaction Cell Cleaning
- Flow Sensor Calibration
- Detector Sensitivity
- Assembling the Dual Plasma Burner for Component Replacement with the SCD
- Assembling the Dual Plasma Burner for Component Replacement with the NCD
- Tube Replacement for the SCD
- Tube Replacement for the NCD
- Troubleshooting
- Index
Operation and Maintenance Manual 45
Step 2: Unpack and Inspect the Instrument
Before unpacking boxes, inspect them for signs of physical damage. If damage
is observed, photographs should be taken in order to make a claim with the
carrier should any equipment damage be found. Check contents of boxes
against the shipping documents. Contact Agilent as soon as possible should a
discrepancy be found.
Required Installation Tools
The following tools are recommended for installation of both the 355 SCD and
255 NCD:
• One adjustable wrench, with adjustment up to 1 inch (2.5 cm)
• One 1/4"-5/16" open-end wrench
• Two 3/8"-7/16" open-end wrenches
• Two 3/4"-9/16" open-end wrenches
• One 5/8" open-end wrench
• One 1/4" Nutdriver with hollow shaft (for FID restrictor)
• One Phillips head screwdriver
• One pair cotton gloves (for hand protection)
• One small flat-head screwdriver