Technical data
Table Of Contents
- Contents
- Introduction
- System Description
- Installation
- Overview
- Step 1: Selecting a Location
- Step 2: Unpack and Inspect the Instrument
- Step 3: Set Up the Vacuum Pump
- Step 4: Connect the Power Cord
- Step 5: Install the Dry Compressed Air or O2 Supply
- Step 6: Install the Signal Output Cables
- Step 7: Install the Dual Plasma Burner
- Step 8: Install the Dual Plasma Controller
- Step 9: Install Column Connections
- Step 10: Install the Transfer Line
- Front Panel Controls and Initial Startup
- Operation
- Maintenance
- Pump Maintenance
- Cleaning the Detector
- Changing the Oil Mist Filter (RV5)
- Reaction Cell Cleaning
- Flow Sensor Calibration
- Detector Sensitivity
- Assembling the Dual Plasma Burner for Component Replacement with the SCD
- Assembling the Dual Plasma Burner for Component Replacement with the NCD
- Tube Replacement for the SCD
- Tube Replacement for the NCD
- Troubleshooting
- Index
22 Operation and Maintenance Manual
Dual Plasma Burner Height: 12.3 in (31.2 cm)
Diameter: 4.0 in (10.2 cm)
Weight: 1.9 lbs (0.9 kg)
Oil Sealed Vacuum Pump (RV5) Height: 10.3 in (26.1 cm)
Width: 6.0 in (15.2 cm)
Depth: 16.9 in (43.0 cm)
Weight: 47.3 lbs (21.5 kg)
or
Oil Free Dry Piston Pump Height: 12.0 in (30 cm)
Width: 9.0 in (22.9 cm)
Depth: 14.0 in (35.6 cm)
Weight: 29.9 lbs (13.6 kg)
Installation Category II
Pollution Degree 2
Ambient Temperature 50 - 104 °F (10-40 °C)
Relative Humidity Up to 95%, noncondensing
Normal Operating Environment Intended for indoor use only
Maximum Altitude 2,000 m (6,562 ft)
Mains Supply Voltage Fluctuation not to exceed 10% of nominal
voltage