User guide

54 Advanced User Guide
2 Configuration
To configure an injector (7683 ALS)
This section applies to the 7683 ALS system. To configure the
7693A sampler system, see the 7693A Installation, Operation,
and Maintenance manual.
1 Press [Config][Front Injector] or [Config][Back Injector].
2 Scroll to Front/Back tower.
3 Press [Off/No] to change the present tower position from
INJ1 to INJ2 or from INJ2 to INJ1.
4 If the installed turret has locations for multiple solvent
bottles, scroll to Wash Mode, press [Mode/Type], and then
select 1, 2, or 3 bottles for each solvent and press [Enter].
5 Scroll to [Syringe size]. Enter the size of the syringe that is
installed and press [Enter].