User guide

Cables 13
Advanced User Guide 357
Signal connectors
SIG1 and SIG2 are for the two analog output signals.
REMOTE connector
Provides a port to remotely start and stop other instruments. A
maximum of 10 instruments can be synchronized using this
connector. See “Using the Remote Start/Stop cable” on page 358
for more detail.
EVENT connector
This connector provides two passive contact closures and two
24- volt outputs for controlling external devices. The outputs are
controlled by valve drivers 5 through 8.
BCD input connector
This connector provides two control relays and a BCD input for
a stream selection valve.
RS-232 connector
This connector is reserved for future development.
LAN connector
Standard Local Area Network connector, for communication
with data systems and other devices.
CAUTION
This connector is similar to the EVENT connector. Plugging a
non BCD cable into the BCD connector can damage the GC.