User guide

270 Advanced User Guide
8 Inlets
5
Loosen the hex nut connecting the split vent line to the
interface until you can remove the line. Put the line aside.
You do not need to plug it.
6 Install a blanking nut into the split line port and
finger- tighten the nut. Tighten the nut an additional
1/4- turn using two wrenches in opposition.
7 Place the interface in the heater block. Replace the clamping
plate you removed earlier and tighten the screw until snug.
Do not overtighten. If you removed the transfer line, replace
it.