User guide

114 Advanced User Guide
5 Methods and Sequences
To save a sequence
1 Press [Store][Seq].
2 Enter an identifying number for the sequence.
3 Press [On/Yes] to store the sequence. Alternatively, press
[Off/No] to cancel.
A message is displayed if a sequence with the number you
selected already exists.
• Press [On/Yes] to replace the existing sequence or [Off/No]
to cancel.
Sequences can also be stored from within the stored sequence
list ([Seq]) by scrolling to the appropriate sequence number and
pressing the [Store] key.
To load a stored sequence
Press [Load][Seq]. Supply the sequence number and press
[Enter]. The specified sequence will replace the current active
sequence.
To determine sequence status
Press [Seq Control] to display the current status of the active
sequence. There are six possible sequence status modes:
• Start/running
• Ready wait
• Paused/resume
• Stopped
• Aborted
• No sequence
To start a sequence
Press [Seq Control], scroll to Start sequence and press [Enter].
The sequence status will change to Running. The sequence
continues to run until all subsequences are executed, or until
one of the events described under “To abort a sequence” on
page 115 occurs.