User guide

24 Multimode Source for 6100 Series Single Quad LC/MS User Guide

2 Installation

Step 1. Prepare to install

The Multimode Enablement Kit, G1978-60451, is shipped with the multimode

source. This kit needs to be installed before the multimode source is used.

Note that the multimode source and its accessories are to be installed by an

Agilent Customer Engineer.

1 Check that the Multimode Enablement Kit contains the following parts:

• Multimode Bd HV cable, p/n G1960-60858

• Multimode HV PCA, p/n G1960-61015

• Multimode Bd Power/Data Cable, p/n G1960-60873

Figure 7 From left to right: G1960-60858, G1960-61015 and G1960-60873

2 Install the APCI Enablement Kit, G1947-60451, which is shipped with the

multimode source.

The APCI Enablement kit contains the following parts:

• Fast APCI HV Supply, p/n G1946-80058

• Valve BD-APCI supply, p/nG1960-60802

• Valve BD-APCI Needle Interlock, p/n G1960-60856

Figure 8 From left to right: G1946-80058, G1960-60802 and G1960-60856