Technical data
Table Of Contents
- Content
- Installation
- Set-Up
- Installation Verification
- Step 1. Auto tune
- Step 2. Set up method names and parameters
- Step 3. Create MMCHECKTOF_EI_POS.m
- Step 4. Create MMCHECKTOF_EI_NEG.m
- Step 5. Create MMCHECKTOF_CI_POS.m
- Step 6. Create MMCHECKTOF_CI_NEG.m
- Step 7. Create MMCHECKTOF_MX_EI POS_CI POS.m
- Step 8. Create MMCHECKTOF_MX_EI NEG_CI NEG.m
- Step 9. Run each of the methods created
- Step 10. Calculate the response of Multimode Demo
- Step 11. Fill out Multimode Report for calculation of peak heights
- Index
7
Agilent G1978B Multimode Source for 6500 Series Q-TOF LC/MS
Set-Up Guide
Agilent Technologies
1
Installation
Step 1. Prepare to install 8
Step 2. Install the HV control PCA and cables 9
To remove the multimode source 13
To convert from multimode to ESI or APCI 14
To convert from ESI or APCI to the multimode source 15
This chapter contains instructions to install the multimode source on a 6510
Series Q-TOF LC/MS system, and also to remove and replace the source.