Technical data

Contents
Multimode Source for 6510 Q-TOF LC/MS Set-Up Guide 5
Content
1 Installation 7
Step 1. Prepare to install 8
Step 2. Install the HV control PCA and cables 9
To remove the multimode source 13
To convert from multimode to ESI or APCI 14
To convert from ESI or APCI to the multimode source 15
2 Set-Up 21
To set up a method to use the multimode source 22
To open the multimode source 24
To check tuning with the multimode source 25
3 Installation Verification 27
Step 1. Auto tune 28
Step 2. Set up method names and parameters 29
Step 3. Create MMCHECKTOF_EI_POS.m 30
Step 4. Create MMCHECKTOF_EI_NEG.m 32
Step 5. Create MMCHECKTOF_CI_POS.m 34
Step 6. Create MMCHECKTOF_CI_NEG.m 36
Step 7. Create MMCHECKTOF_MX_EI POS_CI POS.m 38
Step 8. Create MMCHECKTOF_MX_EI NEG_CI NEG.m 40
Step 9. Run each of the methods created 42
Step 10. Calculate the response of Multimode Demo 50
Step 11. Fill out Multimode Report for calculation of peak heights 51