Technical data
Table Of Contents
- Content
- Installation
- Set-Up
- Installation Verification
- Step 1. Auto tune
- Step 2. Set up method names and parameters
- Step 3. Create MMCHECKTOF_EI_POS.m
- Step 4. Create MMCHECKTOF_EI_NEG.m
- Step 5. Create MMCHECKTOF_CI_POS.m
- Step 6. Create MMCHECKTOF_CI_NEG.m
- Step 7. Create MMCHECKTOF_MX_EI POS_CI POS.m
- Step 8. Create MMCHECKTOF_MX_EI NEG_CI NEG.m
- Step 9. Run each of the methods created
- Step 10. Calculate the response of Multimode Demo
- Step 11. Fill out Multimode Report for calculation of peak heights
- Index
27
Agilent G1978B Multimode Source for 6500 Series Q-TOF LC/MS
Set-Up Guide
Agilent Technologies
3
Installation Verification
Step 1. Auto tune 28
Step 2. Set up method names and parameters 29
Step 3. Create MMCHECKTOF_EI_POS.m 30
Step 4. Create MMCHECKTOF_EI_NEG.m 32
Step 5. Create MMCHECKTOF_CI_POS.m 34
Step 6. Create MMCHECKTOF_CI_NEG.m 36
Step 7. Create MMCHECKTOF_MX_EI POS_CI POS.m 38
Step 8. Create MMCHECKTOF_MX_EI NEG_CI NEG.m 40
Step 9. Run each of the methods created 42
Step 10. Calculate the response of Multimode Demo 50
Step 11. Fill out Multimode Report for calculation of peak heights 51
In this chapter, you create and run methods to check out the system.