Technical data

Agilent Signal Generators Programming Guide 307
6 Creating and Downloading User–Data Files
NOTE Some features apply to only the E4438C with Option 001, 002, 601, or 602 and E8267D with
Option 601 or 602. These exceptions are indicated in the sections.
On the Agilent MXG, the internal baseband generator speed upgrade Options 670, 671, and
672 are option upgrades that require Option 651 and 652 to have been loaded at the factory
(refer to the Data Sheet for more information). Any references to 651, 652, or 654 are
inclusive of 671, 672, and 674.
The following sections and procedures contain remote SCPI commands. For front panel key
commands, refer to the User’s Guide, Key and Data Field Reference (ESG and PSG), or to
the Key Help in the signal generator.
For the N5161A/62A the softkey menus and features mentioned in this chapter are only
available through the Web–Enabled MXG or through SCPI commands. Refer to “Using the
Web Browser” on page 11 and to the SCPI Command Reference.
This chapter explains the requirements and processes for creating and downloading user–data, and
contains the following sections:
• User File Data (Bit/Binary) Downloads (E4438C and E8267D) on page 315
• Pattern RAM (PRAM) Data Downloads (E4438C and E8267D) on page 338
• FIR Filter Coefficient Downloads (N5162A, N5182A, E4438C and E8267D) on page 352
• Using the Equalization Filter (N5162A and N5182A with Options 651, 652, 654 Only) on page 356
• Save and Recall Instrument State Files on page 357
• User Flatness Correction Downloads Using C++ and VISA on page 368
• Data Transfer Troubleshooting (N5162A, N5182A, E4438C and E8267D Only) on page 372