User`s guide

Choosing a Report Format
2-16 Recording an ECG
Changing the Report Format
To change the report format:
1. Press . The bottom of the display will be similar to the one shown
below.
2. Press to select between Auto or Manual report menus. Note that
the data displayed above the and softkeys will change as
you switch between the Auto and Manual report formats.
3. Press to select the report presentation. The selections are:
l Auto Formats: 3x4, 3x4 1R, 3x4 3R, 6x2
l Manual Formats: 3, 6, 12
4. Press or , if available for your format, to select the leads you
wish to record.
Auto Report Formats
12-lead Auto reports may be displayed in 3x4 or 6x2 formats. The 6x2 format
displays longer segments of waveform information than the 3x4 format.
Rhythm strips may be added to the 3x4 format to display longer ECG
segments from one (or three) leads. For the 3x4 1R and 3x4 3R formats, the
rhythm lead(s) may be configured to be any one (or three) of the 12 available
leads. Refer to Figures 2-1 through 2-6 for examples of these Auto report
formats.
Manual Report Formats
Manual ECGs run continuously, from the time you press until you
press . The cardiograph can be configured to display Manual reports
with either 3, 6, or 12 leads. Manual ECGs reflect the ECG waveform as it
occurs with a small delay.
Auto
Report
3x4,3R
Format
I,II,III
Leads
25mm/s
Speed
1.0
Size
6WRS
5HSRUW
)RUPDW /HDGV
)RUPDW
/HDG /HDGV
0DQXDO
6WRS