User`s guide

Recording an Auto ECG
PageWriter 200/300pi M1771A/1770A Cardiograph 2-13
2
l The key sequence is:
3x4 1R: I
⇒ ΙΙ ⇒ ΙΙΙ ⇒
aVR
⇒ aVL ⇒
aVF
⇒
V1
⇒
V2
⇒
V3
⇒
V4
⇒
V5
⇒
V6
⇒
I ...
3x4 3R: Custom Leads
⇒ Ι, ΙΙ, ΙΙΙ ⇒
aVR, aVL, aVF
⇒
V1, V2, V3
⇒
V4, V5, V6
⇒
Custom Leads ...
l The key sequence is: 25
⇒
50
⇒
25 ...(numbers indicate chart
speed in mm/sec).
l The key sequence is: 1.0
⇒
1.0 ½V
⇒
2.0
⇒
2.0 ½V
⇒
0.5
⇒
0.5 ½V
⇒
1.0 ...
l The key sequence is an On/Off toggle. When is active,
Filter is displayed on the screen.
6. Press on the front panel.
l If you did not enter a patient ID in the above step and have not
entered a patient ID since turning on the cardiograph, the message No
ID, Continue? is displayed. Press to record the ECG
without a patient ID. Press to enter patient ID information.
l If you did not enter a patient ID in the above step but have entered
patient ID information since the cardiograph was turned on, the
question Continue using Old ID? is displayed.
If you have entered a patient identification number and want to take
more ECGs from the same patient, press .
If you are recording an ECG from another patient, press
or .
NOTE Your cardiograph automatically checks for a patient ID each time you start an
ECG, unless it is configured for no patient ID information. To bypass this
check and use the last entered patient ID information, press a second
time.
7. The status messages Acquiring ECG..., Processing...,
Analyzing... and Printing... are displayed.
Leads
Speed
Size
)LOWHU
)LOWHU
$XWR
Ye s
No, Enter ID
Ye s
No, Edit Old ID
No, Enter New ID
$XWR