User`s guide

Setting Up the Telephone Directory (Options #A05 or
PageWriter 200/300pi M1771A/1770A Cardiograph A-15
A
2. Turn the modem power switch off.
3. Insert the 9-pin female subminiature D connector end of the modem data
cable into the RS-232 connector on the back of the cardiograph.
4. Refer to your modem manual for instructions on connecting the modem to
the modem data cable, the modem power cable, and the telephone line.
5. Turn the modem on.
6. Turn the cardiograph on.
WARN ING Equipment connected to the cardiograph’s RS-232 connector can cause ground leak-
age current exceeding the maximum specified in IEC 601-1 safety standards. Do not
connect any equipment to the RS-232 connector during cardiograph operation when
the patient cable is connected to a patient.
Setting Up the Telephone Directory (Options #A05
or StressWriter only)
To transmit or receive ECGs from a remote site, you must identify the remote
site, its telephone number and the type of transmission the cardiograph should
send or receive. You can enter the telephone numbers of up to four remote
sites in the directory. To setup the telephone directory, perform the following
steps:
1. Select Setup Telephone Directory from the configuration menu.
The telephone directory appears with four lines for entering remote site
telephone numbers and transmission types.