Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
7HVWLQJ0DLQWDLQLQJWKH$JLOHQW996HULHV
Testing & Maintaining
the Agilent V24/V26
Series
3HUIRUPLQJ((3520&ORQLQJ
You can use this function to copy EEPROM configurations from one unit to another, rather
than program settings individually for each monitor.
From the Monitor Setup screen, press the softkey to display the
EEPROM Cloning screen shown below. You can use this screen to perform two separate
operations:
a. ToUHDG user settings from the monitor to the programming tool, for use in cloning
other monitors.
b. To SURJUDP user settings from the programming tool onto a V24/V26 Series monitor
during cloning operations.
7R5HDG6HWWLQJVWRWKH7RRO
Press followed by to store the monitor’s user settings on the
programming tool. The message... Reading EEPROM is displayed, followed by the
message... Settings stored in local memory when the read process is
complete
7R3URJUDP6HWWLQJVWRWKH0RQLWRU
Press followed by to program the monitor with the
configuration settings from the programming tool. The message... EEPROM programming
in progress is displayed, followed by the message... Programming done when the
cloning process is complete.
:KHQ\RXKDYHFRPSOHWHGWKHFORQLQJSURFHVVUHYLHZWKHGLVSOD\HGLQIRUPDWLRQWR
HQVXUHWKDWWKHFRUUHFW((3520FRQILJXUDWLRQKDVEHHQSURJUDPPHG
7KH((3520FRQWHQWVDUHVWRUHGLQWKHSURJUDPPLQJWRROQRWRQWKHIODVKFDUG
$IWHUFORQLQJRSHUDWLRQVSHUIRUPWKH³3HUIRUPDQFH$VVXUDQFH7HVW´LQGLFDWHGLQWKLV
FKDSWHU
((3520&ORQLQJ
Read Settings Confirm
Program Settings Confirm
127(6