Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
7HVWLQJ0DLQWDLQLQJWKH$JLOHQW996HULHV
Testing & Maintaining
the Agilent V24/V26
Series
6WHS Press the softkey to display the Application Software
Upgrade screen.
6WHS Press the softkey, followed by the hardkey
to
complete the
upgrade, a process which takes approximately 2 minutes. Once the
process is completed, the system displays the message SW upgrade com-
plete.
6WHS Press the hardkey to return to the Instrument Configuration
screen.
6WHS To upgrade the EEPROM, proceed to the next section, otherwise power down the
monitor, disconnect the Flash Programming Tool and reinstall the service port con-
nector cover.
6WHS Power up the monitor and erase the Status Log. (Press ,
, , and .)
6WHS Perform the Performance Assurance test indicated in this chapter.
6RIWZDUH8SJUDGH
3URJUDP
6RIWZDUH
6RIWZDUH8SJUDGH
Monitor Serial Number is
Current SW Release is
New Revision will be
3609A07285
M1204-1401E
M1204 Model V24 Bedside Monitor, L.00.03
L.00.03 M1204-1401F APPLICATION CPU BOOTROM
1H[W
5HOHDVH
)LJXUH$SSOLFDWLRQ&386RIWZDUH8SJUDGH6FUHHQ
Config Mode active - NO MONITORING!
M1204 UPGRADE A
L_00_03
L.00.03 M1204-1401F APPLICATION PROMPACK (ENG)
:
:
:
3URJUDP6RIWZDUH Confirm
Monitor Setup
Monitor Setup
0RUH&KRLFHV 6WDWXV/RJ (UDVH6WDW/RJ