Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
7HVWLQJ0DLQWDLQLQJWKH$JLOHQW996HULHV
Testing & Maintaining
the Agilent V24/V26
Series
6WHS Insert the appropriate flash card into the programming tool.
6WHS Connect one end of the service tool cable to the service port connector on the pro-
gramming tool. Depending upon the task to be performed, you will connect the
other end of the cable to the appropriate service port connector on the monitor.
7KHVRIWZDUHYHUVLRQDQGSDUWQXPEHUVVKRZQLQWKLVGRFXPHQWDUHIRUH[DPSOH
SXUSRVHVRQO\7KHQXPEHUVIRUWKHVRIWZDUHZKLFK\RXDUHXSJUDGLQJRU
UHSURJUDPPLQJPD\YDU\
References to the following softkeys are only applicable to programming cards designated
for “Agilent use only”.
1. Edit Serial No.
2. Password Entry
3. More EEPROMs
4. Select EEPROM
87654321
OPEN
Switch #8 MUST
be in the CLOSED
position.
)LJXUH3URJUDPPLQJ7RRO',36ZLWFK6HWWLQJV
CLOSED
Switches 1-7 are not used and their
position is unimportant when using
programming cards designated Agilent uses
only. (The switches DUH used with the
customer use flash card. See Rel. A.0 8SJUDGH
,QVWDOODWLRQ1RWHfor more information.)
127(
127(