Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
7HVWLQJ0DLQWDLQLQJWKH$JLOHQW996HULHV
Testing & Maintaining
the Agilent V24/V26
Series
3HUIRUPDQFH
7HVW(&*
6\QF
6WHS Connect the patient simulator to the ECG
input and the defibrillator to the monitor
ECG-Sync output.
6WHS Configure the patient simulator as
follows:
ECG sinus rhythm
HR = 100 BPM (Amplitude 1 mV)
6WHS Switch defibrillator to simulation mode.
6WHS Check that the marker pulse is displayed
before the T-Wave begins.
Marker pulse is displayed
before T-Wave begins.
7KHVHUHVXOWV
GRQRWKDYHWR
EHUHSRUWHG
3HUIRUPDQFH
7HVW%,6
3,&'6&7HVW
6WHS
In Monitoring mode connect the 6HQVRU
6LPXODWRU
(for maximum usage please
refer to the documentation delivered with
the Sensor Simulator) to the Patient
Interface Cable
6WHS Enter the BIS Task Window by pressing
0RGXOH6HWXS
, followed by %,6.
6WHS Start Impedance Check by pressing 6WDUW
&KHFN
. This brings up the BIS Cyclic
Check TaskWindow. Check the displayed
results.
Electrode 1: 4-6 k
Ω
Electrode 2: 8-12 kΩ
Electrode 3: 1-3 kΩ
7KHVHUHVXOWV
GRQRWKDYHWR
EHUHSRUWHG
3HUIRUPDQFH
7HVW%,6
FRQWLQXHG
'6&7HVW
6WHS
Enter Service Mode
6WHS Enter the BIS Task Window by pressing
0RGXOH6HWXS
, followed by %,6.
6WHS StartTest by pressing 7HVW '6 &. Check
the displayed results.
Module: 7HVWSDVVHG
BIS engine:7HVW SDVVHG
DSC: 7HVWSDVVHG
7KHVHUHVXOWV
GRQRWKDYHWR
EHUHSRUWHG
7DEOH7HVWDQG,QVSHFWLRQ5HTXLUHPHQWV
7HVW%ORFN
1DPH
7HVWRU³,QVSHFWLRQ´WR3HUIRUP ([SHFWHG7HVW5HVXOWV :KDWWR5HFRUG
RQ6HUYLFH
5HFRUG