Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
7HVWLQJ0DLQWDLQLQJWKH$JLOHQW996HULHV
Testing & Maintaining
the Agilent V24/V26
Series
3HUIRUPDQFH
7HVW
6
LGHVWUHDP
&
2 FRQWG
%DURPHWULF3UHVVXUH$GMXVWPHQW3URFHGXUH
Difference = x2
(<= 4 mmHg)
36&3[[
RU
36&)[[
where P = Pass
and F = Fail
3HUIRUPDQFH
7HVW(&*
6WHS
Connect the patient simulator to the ECG
Parameter Module using the Patient
cable.
6WHS Configure the Patient simulator as
follows:
ECG sinus rhythm
HR = 100 BPM (Amplitude 1 mV)
6WHS Check displayed ECG wave and HR value
against the simulator configuration. HR = 120 +/– 2 BPM
7KHVHUHVXOWV
GRQRWKDYHWR
EHUHSRUWHG
3HUIRUPDQFH
7HVW
5HVSLUDWLRQ
6WHS
Connect the patient simulator to the ECG/
Resp Module using the patient cable.
6WHS Configure the patient simulator as
follows:
Base impedance line 1500 Ohm
Delta impedance 0.5 Ohm
Respiration Rate 40/min
6WHS Check displayed respiration rate against
the simulator configuration.
RPM = 40 +/– 2 /min
7KHVHUHVXOWV
GRQRWKDYHWR
EHUHSRUWHG
7DEOH7HVWDQG,QVSHFWLRQ5HTXLUHPHQWV
7HVW%ORFN
1DPH
7HVWRU³,QVSHFWLRQ´WR3HUIRUP ([SHFWHG7HVW5HVXOWV :KDWWR5HFRUG
RQ6HUYLFH
5HFRUG
6WHS $FWLRQ
1
Press %DURPHWHU3UHVVXUH to adjust
the Barometric Pressure value. The
Task Window displays the stored
barometric pressure in mmHg.
2
If the displayed value is incorrect,
use the
%DURPHWHU3UHVVXUHkey to
adjust the value to atmospheric
pressure.
3
Document the Difference (x2)
between the actual atmospheric
pressure and the value displayed by
the monitor.
4
Press &RQILUP to store the displayed
or adjusted value. After about 5
seconds, the message “Adjustment
done” displays. The barometric
pressure is then set to the value you
entered.
5
Press 0DLQ6FUHHQ (or6WDQGDUG
'LVSOD\
) to return to the standard
display in Service mode