Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
5HPRYLQJ5HSODFLQJ3OXJLQ0RGXOHV
Removing & Replacing
Plug-in Modules
5HFRUGHU0RGXOH3DSHU
The recorder will not run when the door is open or when the recorder is out of paper. To
prevent damage to the recorder module, use only Agilent approved paper (Agilent re-order
number 40477A/B)
7R/RDG3DSHULQWRWKH5HFRUGHU0RGXOH
6WHS Remove the empty core from the previous roll of paper.
6WHSCut off and discard the first few inches of paper to eliminate any traces of adhesive.
6WHSPull out several inches of paper from the new roll, holding the roll with the loose end
hanging over the top toward
you.
6WHSOpen the door and push the paper roll into the holders in the recorder.
6WHSThread the paper under the roller and over the plastic shelf far enough so it goes
around the roller and comes out above it.
6WHSDrape the paper over the end of the door and close the door. The paper should be vis-
ible and draped down in front of the door.
5
STEP
PLASTIC
SHELF
PAPER
ROLLER
3
STEP
6
STEP