Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
5HPRYLQJ5HSODFLQJ3OXJLQ0RGXOHV
Removing & Replacing
Plug-in Modules
WFS2

WFS&2

&DOLEUDWLRQ&KDPEHU.LW
7R5HPRYHWKH&DOLEUDWLRQ&KDPEHU
6WHS Using a flat-tipped screwdriver, remove the screw holding the calibration chamber
in place on the front of the plug-in module.
6WHS Lift the chamber off the plug-in module. Ensure that the white plastic switch tip
located in the module is not lost.
7R5HSODFHWKH&DOLEUDWLRQ&KDPEHU
6WHS Ensure the white plastic switch tip is in place in the plug-in module.
6WHS Place the calibration chamber in the allocated position on the plug-in module.
6WHS Insert and tighten the screw into the calibration chamber, securing it to the plug-in
module.
O2/CO2
CAL
tcpO /tcpCO
M1018A
7
80x100
2
2
CALIBRATION
CHAMBER