Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
5HPRYLQJ5HSODFLQJ3OXJLQ0RGXOHV
Removing & Replacing
Plug-in Modules
7R5HPRYHD3OXJ,Q0RGXOH
6WHS Remove the Front Housing.
a. Place the module on a flat surface and insert a card (similar to a credit or cheque type
card) into one side of the module to disengage the 2 tabs securing the front housing
to the module housing.
b. Pull the edge of the front housing away from the module housing.
c. Carefully turn the module over so the free edge does not reengage and repeat steps a)
and b) on the other side of the module. The front housing should now be free of the
module housing.
6WHS Press the 4 tabs on the front rim of the module housing and remove the module
housing from the internal frame and PCB.
6WHS Press the 2 tabs on the top and 2 tabs on the bottom of the frame and pull the frame
clear of the PCB.
6WHS Replace the appropriate connector, switches and LEDs on the module.
7R5HSODFHD3OXJLQ0RGXOH
6WHS Seat the connectors and PCBs into position in the frame.
6WHS Carefully snap-lock the frame together with the module PCB inside.
6WHS Re-insert and snap-fit the frame into the module case so the front and rear
connectors align with the module case.
6WHS Snap-fit the front housing onto the front of the module case so the openings in the
front housing match the LEDs and keys.