Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
)URQW+RXVLQJ$VVHPEO\9&9&9&79&7
Front Housing Assembly
V24C/V26C & V24CT/
V26CT
5HSODFLQJWKH%RDUG6KLHOG
 Place the Board Shield on the Flat Panel Bracket.
 Screw in the 2 hex stand-off screws (5mm) located in the narrow channel securing the
Board Shield and Flat Panel Bracket to the top of the Front Housing.
 Screw on the 4 hex nuts (5.5mm) securing the rest of the Board Shield to the Flat Panel
Bracket.
5HSODFLQJ3DUDPHWHU0RGXOH5DFN$VVHPEO\0
 Align the slides on the Front End Rack Assembly with the mating slides on the monitor.
 Slide the Front End Rack Assembly downward until it snaps into place.
 Parameter modules can now be inserted into the parameter module rack assembly by slid-
ing them into the rack until they snap into place.
5HSODFLQJ/HDG$FLG%DWWHULHV&7PRGHO
 Remove power to the instrument by pressing the power switch to OFF and disconnecting
the AC power cord.
 At rear of the instrument, open battery door (swings downward).
 Slide lead-acid battery into chamber until it snaps into place. Repeat for other battery if
necessary.