Specifications

$JLOHQW0$996HULHV6HUYLFH*XLGH
)URQW+RXVLQJ$VVHPEO\9&9&9&79&7
Front Housing Assembly
V24C/V26C & V24CT/
V26CT
5HSODFLQJ)URQW+RXVLQJ.H\SDG
 Verify power to the monitor is OFF and that the AC power cord is disconnected.
 If it is a CT model, verify that the Lead-Acid batteries have been removed.
 Insert the keypad onto the Front Housing.
 Replace four nuts securing Keypad to the Front Housing.
 Install the Flat Panel Display Assembly.
 Install the Front Housing Assembly.
5HSODFLQJWKH)ODW3DQHO%DFNOLJKW
If your monitor has the new flat screen display some of the reassembly procedures will be
slightly different from the following sections. Refer back to the disassembly procedures
(page 9-13 to page 9-17) for the detailed differences. You can check which display you have
by looking at the serial number on the right-hand side of the monitor. Options 026, 027, 028
and 029 have the new display. All other options (020 - 025) have the old display.
When installing the backlight, carefully place the Flat Panel Display with display side down
on a clean flat surface.
Do not touch fluorescent tube when removing or installing the backlight as oil from finger
prints will shorten the operating life of the tube.
 Verify power to the monitor is OFF and that the AC power cord is disconnected.
 If it is a CT model, verify that the Lead-Acid batteries have been removed.
127(127(
127(